x-session (and maybe also others) and eq-three problem

deepfunktribal · Post by **deepfunktribal** » Mon Nov 07, 2005 11:20 am

when i assign a rotary to the GainLow (also mid and high) and set the range to max. 0db i cannot go down as much needed by rotating the rotary - setting the range to "normal" does make problems because then it is not possible to see if 0db are applyed because this thereafter will not be in middle of the rotary on the xsession and so unusable ...
any tip how to use the full range of the roary and having the 0 db in middle of the rotary range ?

madlab · Post by **madlab** » Tue Nov 08, 2005 6:31 pm

did you try to select - 64 to +63 values for the rotary control on the X-Station ?

alan* · Post by alan* » Wed Nov 09, 2005 1:01 am

or use eq4 instead

deepfunktribal · Post by **deepfunktribal** » Wed Nov 09, 2005 10:32 pm

did you try to select - 64 to +63 values for the rotary control on the X-Station ?

in ableton i can only select from -x to +6 - should i set something on the x-session controller itselfe ? but the problem will still be that there is no possibility to have the rotary knobs on the x-session in middle settings because it does not correspond to the gui in ableton...

eq4 - how to use it with x-session midi interface

alan* · Post by alan* » Thu Nov 10, 2005 1:33 am

i only have uc33e not x session but I imagine it's the sam to asign the knobs, you can set eq 4 up as a 3 band eq if you want as far as i can see it would do the same thing except when the knob is cetered so is the eq