live hardware buffer
live hardware buffer
I am using Live on a powerbook g3/500. I am getting good performance except for the fact that I cannot set the hardware buffer as it suggests I can do in the manual. My interface is a digidesign mbox which, for now, can only use soundmanager. I am getting drop-outs at about 60% cpu load. Anyone have any suggestions?
Hi Ludi,
I assume you are the one with the MBox...
You're are right that with Live 1.5 it is not possible to set the buffer size for soundmanager.
With a bug fix update (probably released in the next time) you will get this.
I have no MBox here at the moment so i cannot say that it will fix your problem.
A general issue concerning USB devices is that sometimes there are problems by using 2 USB interfaces (maybe 1 x Audio and 1 x Midi) at the same time because the bandwith limitation of the USB Bus in the 1.1 specification.
regards,
Alex
I assume you are the one with the MBox...
You're are right that with Live 1.5 it is not possible to set the buffer size for soundmanager.
With a bug fix update (probably released in the next time) you will get this.
I have no MBox here at the moment so i cannot say that it will fix your problem.
A general issue concerning USB devices is that sometimes there are problems by using 2 USB interfaces (maybe 1 x Audio and 1 x Midi) at the same time because the bandwith limitation of the USB Bus in the 1.1 specification.
regards,
Alex