volume of clips

Sebastian · Post by **Sebastian** » Mon Dec 18, 2006 1:43 pm

Hi

Is there a way to independently set the volume of clips other than using the pencil and drawing the volume lines and dots?

Spiralgroove · Post by **Spiralgroove** » Mon Dec 18, 2006 1:44 pm

yeah its the big slider on the audio clip marked VOLUME

Sebastian · Post by **Sebastian** » Mon Dec 18, 2006 2:04 pm

Im at work ill check later but I think it says GAIN.........?

Tarekith · Post by **Tarekith** » Mon Dec 18, 2006 2:13 pm

There you go then

fatrabbit · Post by **fatrabbit** » Mon Dec 18, 2006 2:36 pm

Here's a general tip for drawing envelopes free-hand - With pencil mode activated (Cmd + B) start drawing an envelope (should be steps at this point, press Apple + 1 or 2 to zoom in or out on the grid)... once you are drawing hold down Apple (Cmd) and you should start drawing freehand. It's still a little blocky, but you can get some good curves out of it!

mg75 · Post by **mg75** » Tue Dec 19, 2006 3:51 pm

how can one master all their clips so they have the same level?
Normalize?

Tarekith · Post by **Tarekith** » Tue Dec 19, 2006 3:58 pm

You need to do it manually with a level meter, I recommend the freebie "Inspector" by RND.