Operator inactive filter

blank · Post by **blank** » Tue Mar 27, 2007 11:32 am

When I use the operator low -24db filter on a patch, when I cut the resonnance of after putting is value at more than 50% and bring it to 0 the filter stop filtering ( become flat) but I did'nt touch the cutoff.

I have to retouch the resonnance ( just a bit ) and the filter comes back to life.

It appears randomly, i'm not using the filter often on operator so I cannot say its a very intensive one.

Amaury · Post by **Amaury** » Tue Mar 27, 2007 12:40 pm

Hi,

Which exact version of Live are you using? On which platform?
So, that happens whenever you set the resonnance of the filter to its minimum? With the mouse? a controller?

I can't reproduce it yet.

Regards,
Amaury

sweetjesus · Post by **sweetjesus** » Tue Mar 27, 2007 12:58 pm

blank wrote:When I use the operator low -24db filter on a patch, when I cut the resonnance of after putting is value at more than 50% and bring it to 0 the filter stop filtering ( become flat) but I did'nt touch the cutoff.

I have to retouch the resonnance ( just a bit ) and the filter comes back to life.

It appears randomly, i'm not using the filter often on operator so I cannot say its a very intensive one.

ive experienced this problem

not had time to send it to save and sent to you guys when it happened but ive had this exact same problem.

that being said, i've got a lot of filters in my recent projects and havent seen this problem for a good month or 2...

EDIT: i had this problem on an autofilter, did not notice this one was operator specific?

DIgiDennis · Post by **DIgiDennis** » Tue Mar 27, 2007 1:21 pm

i think its a feedback safty. but i experince the same

Operator inactive filter

Operator inactive filter

Re: Operator inactive filter