Berhinger BCF MC-C emualation mode for live: an overlayer

felikz · Post by **felikz** » Mon Jun 04, 2007 1:18 pm

Hi folks,

to engage full pleasure along with your BCF and Ableton Live i spend some hours for you to find out, how to use the Berhinger BCF in "Mackie Control Mode for Cubase" in Live. I start the BCF in MC C emulation mode like it's described at the Behringer Website, start the BCFView (verry cool)and run Live. In the preferences of live i choose Mackie Controll as HardwareController. And this is how you use it:

Note: All * descripe the meaning of an active led. for example *rec means, that the track is armed when the LED on the bcf is on.
Other Example: with Shift 2(View),you can see if Live is in Session View (*sess = LED is active) or Arrangment (arr=(without *)LED is off)

Compendre ?
Cheers!

longjohns · Post by **longjohns** » Mon Jun 04, 2007 2:34 pm

Nice one.

Were you aware that this had already been done, and with a printable cut-out overlay?

Have to find the thread...

longjohns · Post by **longjohns** » Mon Jun 04, 2007 2:39 pm

http://img62.imageshack.us/my.php?image ... lay7qs.jpg

note: I think he manually programmed some stuff which is labeled on the black shift layer. those buttons actually just send midi notes which you can map to things of your choosing

felikz · Post by **felikz** » Mon Jun 04, 2007 7:07 pm

k, did not check.

so take it as an live6 update, cause i noticed some changes (see "undo" (verry important!) for example).

cheers.