BCR doesn't like it's sister BCF

zizi · Post by **zizi** » Mon Aug 20, 2007 11:55 pm

I have Vista 64bit and 2 Behringers, the BCF2000 and BCR2000. They both work in Live separatly. But when I have both hooked at the same time, the BCF always shows up twice in Live's midi preferences page, but the BCR isn't. Then when I try to midimap them, only one works. Sometimes the BCF works, sometimes it's the BCR, randomly.

In Vista device manager, they show up good, with their proper names.

Is there someone using them both with vista? Is there something special to do?

longjohns · Post by **longjohns** » Tue Aug 21, 2007 12:45 am

I beleive with two of these guys you must set unique device ID's

this is done on the units themselves. consult the manual

??

zizi · Post by **zizi** » Tue Aug 21, 2007 9:12 am

That will be the U-mode you're talking about. But it's setup correct, they work very well in XP, but don't in Vista.

And in Vista's device manager, they are registered at different addresses.