Help! Operator - Tweak Pitch Bend

[sundancemusic]

I am using Operator with the most basic sine wave and would like greater control over the pitch bend on my M-Audio axiom49. I tweaked the pitch shell parameter "PB range" to 1, but I would like more "microscopic" control. Is there any way to set this parameter lower, ideally to ".5"

The goal here is to be able to bend a note 15cents out and land perfectly back. Please help!

[sweetjesus]

hello

there is a panel somewhere in operator which reveals a PB (pitchbend) range for u to adjust.

[sundancemusic]

I found the parameter "PB" on the Pitch Shell. The default is +5 and it can be adjusted to +1, but that is too course of a refinement/bend. I am looking to assign the PB to about 50 cents or even 25 through its full range of movement. Is this possible?

[andrewbrewer]

I found the parameter "PB" on the Pitch Shell. The default is +5 and it can be adjusted to +1, but that is too course of a refinement/bend. I am looking to assign the PB to about 50 cents or even 25 through its full range of movement. Is this possible?

i have found that many text-boxes in ableton allow you to type in exact decimals to 7 or so places. so for this pitch bend, try typing in 0.5. it might display as +1, but I bet you will find your bend only going to 50 cents.

[sundancemusic]

The pitch shell PB will not allow you to do less than one. Tweaking the fine tuning knob worked just fine...