Rewiring Logic 5.5.1 + Live 3.0.4

matias · Post by **matias** » Wed Jul 21, 2004 2:19 pm

ne posts that kan help me out...or some1 tell me how to rewire logic/live......... the faq's is only for mac....(logic 6)

matias

paradiddle · Post by **paradiddle** » Wed Jul 21, 2004 3:26 pm

Yo!

You can access rewire by using the CHA parameter on an audio track.

Select audio 1. Where you see CHA on the left of the screen, click the track 1 parameter, you should see a pop-up menu. Now go to Instruments/others/mix L

now select audio 2, repeat the above step and select mix R.

That's all. If you never used rewire before, you have to load logic first then Ableton live. When ya wanna quit, you do the opposite: quit Live then logic.

I tell ya though the Logic rewire implementation is fuzzy wuzzy but it works.

matias · Post by **matias** » Thu Jul 22, 2004 3:47 am

cheers...workin but it crackles abit in logic...is that just rewire ....ive cheked all my buffer settings n they r fine...

ideas??

matias

benblue · Post by **benblue** » Thu Jul 22, 2004 3:58 am

pre logic 6 was only rewire protocol 1. everything else is rewire 2.
so i wont work that great, but it will work. the cycle wont work, if i rememebr correctly.
as far as clicks...not sure..
cheers

paradiddle · Post by **paradiddle** » Thu Jul 22, 2004 10:08 am

I don't get crackles over here. I'm using ASIO on the audiophile with buffer of 128 samples. I'f you bring up the buffers, it still does it?

It is fairly limited though for a rewire implementation like Benblue said. Don't expect much functionality. But it works.