a standard arranger

zaknbou · Post by **zaknbou** » Wed Dec 19, 2007 11:32 pm

hi guys , well if my keyboard (which is a standard arranger) is not listed in the control surface in the midi tab in the preference , so how could i midi map in live ?

zaknbou · Post by **zaknbou** » Thu Dec 20, 2007 12:23 pm

any help guys ....

chrysalis33rpm · Post by **chrysalis33rpm** » Thu Dec 20, 2007 12:32 pm

Have you read the relevant chapter of the manual? If you have, where are you getting stuck?

substance_g · Post by **substance_g** » Thu Dec 20, 2007 12:32 pm

Just configure it manually: check out the "Manual Control Surface Setup" chapter of the manual.

zaknbou · Post by **zaknbou** » Thu Dec 20, 2007 4:45 pm

well i am trying to configure it manually but nothing happen , i enter the midi mode then i press the button (play button ) that i want to control on the track then i press a key (C3) on my arranger but nothing happen , it won't configure .....nothing is added in the midi mapping browser , but what confuse me the most that the arranger is working well as i am using it to play my vsti in live but it don't seems to let me map and secondly the key mode is mapping well so the technique that i am using is right .....any help

chrysalis33rpm · Post by **chrysalis33rpm** » Thu Dec 20, 2007 5:01 pm

Again, have you read the manual - it explains how to set up your prefs so that the messages from your controller are going to the right area of Live (track input, remote input, etc.) Open up your midi prefs tab,is it properly configured?