Ahh Pls help. trying to edit a Dj set i have just done.

beatfreakn · Post by **beatfreakn** » Tue Jan 15, 2008 6:43 am

ok i have just finished recording a set and there are a couple fo bits where i want to use auto filter etc.

I dragged the clip from session into arrangement view and started using automation with record on on the bits i wanted to edit. I finished up. Deleted the old clip out of Session view and dragged the new edited into the session view. I then saved it and exited. When i got back in and listed to the set nothing had freaking saved. None of the Automation or anything.

I just want to edit certain parts. I tried doing it from session view but as i only want to edit little parts here and there in the set The bits i did edit went into arrangement view as different clips so it does not work out either as it jumps from one bit i edited to the other and misses out complete chunks of the song.

What am i doing wrong? Please help i just spent ages editing only to find it didn't save after all that!

Thanks

pepezabala · Post by **pepezabala** » Tue Jan 15, 2008 7:52 am

automation recorded in arrangement is located in arrangement. You can't copy it back into session view. (except if you by copy/paste each envelope separately)

When you do automation/editing in arrangement and you want it back in session view, there are several possibilities: rendering (one or various or all channels with all edits and effects etc. into one stereofile), freezing/flattening (one channel with all edits and effects), consolidating (onec channel, only edits, but no effects). Check them in the manual.