here's the prob:
i have assigned some automation parameters to some kontakt values (say the cutoff frequency of a filter).
i set it to minimum value (say 40Hz), either from kontakt's GUI or from the device slider. the slider will be set at minimum. so far so good.
now i save the Live set.
when i re-open it, i can hear that the frequency is still set at 40Hz, but the slider in the device will be in its middle position, and so will all sliders that have automation.
this is quite bad, since if i send an 'update parameters' message from the preferences, all my controler's knobs will be in their middle position, even if the actual value is minimum.
see what i mean? can somebody reproduce that?
just check that whatever the sliders position was when you saved your project, when you re-open it, all the sliders will be in middle position...