Insert effect/off

hydraphonic · Post by **hydraphonic** » Sat Oct 23, 2004 6:43 am

Hi,

In one channel, I have 2 clips. When one clip plays, I want a certain effect off, when the other plays, I want it on.

Is it possible?

Thanks,

Rob

Vercengetorex · Post by **Vercengetorex** » Sat Oct 23, 2004 10:04 am

You need to read about clip envelopes in the manual... they will allow you to accomplish this quite easily.

hydraphonic · Post by **hydraphonic** » Sat Oct 23, 2004 6:14 pm

Thanks V,

I'm aware of clip envelopes but cannot find a way to direct one to an effect on/off.

Do you know of a way?

ejectorset · Post by **ejectorset** » Sat Oct 23, 2004 7:33 pm

point the clip envelope then at the parameter that will best let you "bypass" it ... for a delay you control the wet/dry with a clip envelope, for a lowpass filter you control the frequency, etc.

set one clip to turn the effect to the desired effect amount, and the other to return the effect to a bypass-like state.

be more specific what effect are you trying to use?

hydraphonic · Post by **hydraphonic** » Sat Oct 23, 2004 9:27 pm

point the clip envelope then at the parameter that will best let you "bypass" it ...

I want to automate Predatohm. Unfortunately there's no wet/dry or on/off within the plugin itself....

Mmm... perhaps I could make a "dry" preset, and change patches.....

ejectorset · Post by **ejectorset** » Sat Oct 23, 2004 9:36 pm

possibly, if not you can use clip envelopes set to mixer and then send A or send B (assuming your effect will work as a send effect as well) and automate the channel's send level.