z3ta won't render

ARDJ · Post by **ARDJ** » Tue Nov 11, 2008 7:22 pm

anyone else had an issue with this recently? i use z3ta a lot but soloing and rendering as master or even rendering the clip individually = zero results. no sound whatsoever.

i'm not even automating anything in the synth... chain goes:

pitch device (automated semitones), z3ta, eq, reverb, autofilter(automated on & off).

solo in place is checked...

losing my mind here, won't render alone or in entire project

linzatti · Post by **linzatti** » Tue Nov 11, 2008 11:32 pm

had a similar problem a long time ago. with a different instrument though. dunno what soolved it.

I guess I just updated everything to the latest versions.

are you rendering in 16bit?

monobeach · Post by **monobeach** » Tue Nov 11, 2008 11:37 pm

did you try to resample it?

ARDJ · Post by **ARDJ** » Wed Nov 12, 2008 6:14 am

resampling ftw! i wonder why this is happening though, quite bizarre.

Low Frequency Obstinator · Post by **Low Frequency Obstinator** » Wed Nov 12, 2008 1:35 pm

get the same with Z3ta and Vanguard also.