Exporting with cubase, PROBLEM

tommi_c · Post by **tommi_c** » Wed Nov 24, 2004 7:38 pm

Hi, I am using cubase SX2 and live 4 in with rewire.
When i come to export my song most of the audio from live is missing, the loops come in intermitantly! What is going on how can i remedy this?
Cheers

ewistrand · Post by **ewistrand** » Wed Nov 24, 2004 8:28 pm

Bounce your Live tracks down to Cubase audio tracks before you try to export.
ew

GO · Post by GO » Thu Nov 25, 2004 5:23 am

Ok, here is the deal: Load your clips into ram in Live and then do your export. It will work. Alternately, upgrade to CubaseSX 3.0...when I did, I no longer needed load Live clips into ram for the export to work. Live 4.0 + CubaseSX 3.0 = bliss! Also, for those that experienced the buzzing noise problem when Cubase 2.x was put in play mode while rewired to Live, this problem is fixed in CubaseSX 3.0.

Chris J · Post by **Chris J** » Sun Dec 05, 2004 6:23 pm

ewistrand wrote:Bounce your Live tracks down to Cubase audio tracks before you try to export.
ew

How do you bounce ? in cubase, rewire tracks can't record, what I've done is using a separate stereo output on my soundcard going in a stereo input, hardware rewiring, but is there an internal way of doing that ?

cheers

(the tip on using ram is good but I've recorded a drum kit with 5 tracks so it's too much for my RAM)

Chris J · Post by **Chris J** » Mon Dec 06, 2004 11:01 am