live 4.04 as rewire slave for logic pro7 - not opening

eric · Post by **eric** » Thu Jan 06, 2005 4:09 pm

trying to use live 4.04 as rewire slave in logic pro7

live is not accepted as rewire slave.

error message: "The Rewire master application has detected a different version of Live than the one last used. Live will not run as ReWire slave unless you restart the current ReWire master application and Live'"

some solutions have been reported in the forum but none of them work out on my system.

what i've tried til now:
logic prefs trashed
live prefs trashed
Friedemanns advice in forum did not work out either
(http://www.ableton.com/forum/viewtopic.php?t=14282)
Ableton Live Engine Alias points to app
Ableton Live Engine Alias trashed
rewire engine trashed
rex shared library trashed, newly installed

live and logic both work perfect in standalone

mac PB 1.5, 1gb ram
osx 10.3.7
logic pro 7
live 4.04
rewire 1.4.7
rex shared library 1.5.4
no network, no internet

thanks for your suggestions
eric

Post by **Alex** » Fri Jan 07, 2005 4:34 pm

Hi eric,

do you have several version of Live on your computer?
Do you have started Live 4.0.4 at least once stand alone?

regards,
Alex

eric · Post by **eric** » Fri Jan 07, 2005 10:41 pm

Alex wrote: do you have several version of Live on your computer?
Do you have started Live 4.0.4 at least once stand alone?

just one version installed: 4.04

in standalone it shows on start: rewire enginge installed (after trashing the prefs). in standalone i have no problems at all...

also logic pro7 works fine in standalone.

thanks in advance

eric

quagerq · Post by **quagerq** » Fri Jul 22, 2005 4:42 am

eric wrote:
Alex wrote: do you have several version of Live on your computer?
Do you have started Live 4.0.4 at least once stand alone?

just one version installed: 4.04

in standalone it shows on start: rewire enginge installed (after trashing the prefs). in standalone i have no problems at all...

also logic pro7 works fine in standalone.

thanks in advance
eric

Hi,

This is an old post I know, but I am having the exact same problem you were descibing (months ago)

Did you ever figure it out?

If so could you share the solution?

Thanks

quagerq · Post by **quagerq** » Fri Jul 22, 2005 4:43 am

eric wrote:
Alex wrote: do you have several version of Live on your computer?
Do you have started Live 4.0.4 at least once stand alone?

just one version installed: 4.04

in standalone it shows on start: rewire enginge installed (after trashing the prefs). in standalone i have no problems at all...

also logic pro7 works fine in standalone.

thanks in advance
eric

Hi,

This is an old post I know, but I am having the exact same problem you were descibing (months ago)

Did you ever figure it out?

If so could you share the solution?

Thanks