Faders seem to be linked in parallel, broken signal flow!

[Psykid]

I've noticed a bit of backwards signal flow in a recent live session that I can't explain, leading me to think something is bugging. I had this problem in 7.0.15, and just upgraded to 7.0.16, but the problem remains.

Here's the setup:


I have a keyboard coming into an audio track called "Piano" in Live on External Inputs 1-2. I'm routing that to the Master, nothing fancy here. On a separate audio track called "pianoverb", I'm taking the signal from "Piano" (prefx) and running it through some verb. I then route "pianoverb" to the Master. So far, really straightforward stuff. Now, when I pull down 'pianoverb', the signal from "Piano" dies with it, which doesn't make any sense since "Piano" is going to the Master. Even weirder, pulling down "Piano" causes the exact same thing to happen to "pianoverb" I.E. the signal dies in that track too, which shouldn't happen because "pianoverb' should be taking it's input prefader. Any sends I'm using (all prefader in this case) also die when I pull down either track.


To make a long story short, pulling down either fader kills the signal entirely, as if they were somehow linked or grouped. Any thoughts?

The only piece of gear I've added to my setup lately is an Mbox2 Pro, replacing my old MOTU 828 mkII.

[[dfi]]

Hi Psykid,

that sounds strange..
can you send me the respective set to [email protected]?
i want to take a look at it..
just the set, no samples needed...

best,
dfi