Using the Roland FC300 for looping

[modulus10]

OK so I am still a newbie here, but i must say im loving the abelton live 8 for live looping - i moved up frmo a roland rc-50 and i am DIGGING This stuff!

However

is there a way, to use a single pedal to control a loop in a similar fashion as im used to on the rc-50? meaning that if I set switch 1 to start the loop, can i use switch 1 again to stop the loop, and then again ue switch 1 to rearm the loop?

I currently have to assign 3 different switches 1 to start 1 to play back and 1 to over dub - is there a better way to do this?

thanks in advance

C

[modulus10]

oops wrong section - my apologies