loadbang
loadbang
Did I miss something or loadbang doesn't work when I put a plugin on a new track?
MacBookPro, OSX 10.6.4, MOTU Ultralite
Live Suite 8, MaxMSP 5, Max For Live, Logic Studio 9, Wave Editor
http://www.brakmolotov.net
http://www.soundcloud.com/meriol_lehmann
Live Suite 8, MaxMSP 5, Max For Live, Logic Studio 9, Wave Editor
http://www.brakmolotov.net
http://www.soundcloud.com/meriol_lehmann
Re: loadbang
OK, I didn't find my answer about loadbang but I just realized there's a better way to initialize settings. In the Inspector panel, you can check "inital enable" and set an initial value.
MacBookPro, OSX 10.6.4, MOTU Ultralite
Live Suite 8, MaxMSP 5, Max For Live, Logic Studio 9, Wave Editor
http://www.brakmolotov.net
http://www.soundcloud.com/meriol_lehmann
Live Suite 8, MaxMSP 5, Max For Live, Logic Studio 9, Wave Editor
http://www.brakmolotov.net
http://www.soundcloud.com/meriol_lehmann
-
- Posts: 68
- Joined: Tue Sep 01, 2009 4:07 pm
Re: loadbang
loadbang should work fine. Can you send along a simple patch that shows your problem? In an unlocked patcher (max device in the editor), you can select all and choose copy compressed from the Edit menu and paste it into your response here.
all the best,
-Ben
Cycling '74
all the best,
-Ben
Cycling '74
Re: loadbang
Finally found that loadbang is working fine but there's a problem with live.dial. If I send it a value of 100 with a loadbang, the number at the bottom changes but the dial stays at 0 unless I sent the value again.
MacBookPro, OSX 10.6.4, MOTU Ultralite
Live Suite 8, MaxMSP 5, Max For Live, Logic Studio 9, Wave Editor
http://www.brakmolotov.net
http://www.soundcloud.com/meriol_lehmann
Live Suite 8, MaxMSP 5, Max For Live, Logic Studio 9, Wave Editor
http://www.brakmolotov.net
http://www.soundcloud.com/meriol_lehmann
-
- Posts: 127
- Joined: Fri Sep 11, 2009 7:54 am
- Location: Paris
- Contact:
Re: loadbang
To initialize a live.* UI object, use the initial feature:mlehmann wrote:Finally found that loadbang is working fine but there's a problem with live.dial. If I send it a value of 100 with a loadbang, the number at the bottom changes but the dial stays at 0 unless I sent the value again.
- check the initial enable attribute in the inspector
- set the initial value
ej