Everytime we open Logic (or Pro Tools) with Dae, LIVE is not able to run in rewire mode.
Error-Message:
"Live has detected another ReWire Master Program. To run in REWIRE Slave Mode you have to Quit this Program and restart LIVE".
Is somebody able to use Rewire with Pro Tools (or Logic with DAE)?
[/b]
Rewire with ProTools
Hi Thomas,
as you already experienced, it is not possible to run Live as ReWire slave to Logic when it uses DAE. This is because Logic has a different behavior when using DAE which cannot be handled from Live.
We hope to get it to work in the future but it will need a bigger internally rebuild and therfore time so we can not provide it within the bugifx update (Live 4.0.2) coming soon. Sorry for that.
regards,
Alex
as you already experienced, it is not possible to run Live as ReWire slave to Logic when it uses DAE. This is because Logic has a different behavior when using DAE which cannot be handled from Live.
We hope to get it to work in the future but it will need a bigger internally rebuild and therfore time so we can not provide it within the bugifx update (Live 4.0.2) coming soon. Sorry for that.
regards,
Alex
-
plastikninja
- Posts: 3
- Joined: Fri May 23, 2003 10:04 pm
Rewire
Do I read this correctly? You get the same when using Logic AND ProTools?
If so, it simply tells you that Live is open and sees itself as a Rewire master. When you then open ProTools, which will not run as a Rewire slave, Live tells you that there is now another Rewire master (only) application open, and it asks you to close Live and then open it again-while ProTools is already open-so that Live can be used as a Rewire slave.
The start-up sequence is the key: start Pro-Tools first, then Live.
In addition to the trouble described when using Logic, also note that until 4.0.2 comes out, you can't use sample rates higher than 44.1 in ProTools sessions. Rewired audio from Live only runs at 44.1 right now !
If so, it simply tells you that Live is open and sees itself as a Rewire master. When you then open ProTools, which will not run as a Rewire slave, Live tells you that there is now another Rewire master (only) application open, and it asks you to close Live and then open it again-while ProTools is already open-so that Live can be used as a Rewire slave.
The start-up sequence is the key: start Pro-Tools first, then Live.
In addition to the trouble described when using Logic, also note that until 4.0.2 comes out, you can't use sample rates higher than 44.1 in ProTools sessions. Rewired audio from Live only runs at 44.1 right now !