Page 1 of 1
How do i skip bars in the arrangement view
Posted: Fri Dec 04, 2009 1:03 am
by Star69
Hi guys
while cutting/splitting up an amen break in the arrangement view (using command e)
how do i skip to the next bar so i don't have to click the place on the break where i want to split it ?
Re: How do i skip bars in the arrangement view
Posted: Fri Dec 04, 2009 1:23 am
by mode:masters
One way is to set markers in the arrangement and map the markers to a button.
Put the cursor where you would like to set a marker and in the top right section of the arrangement view you will see a "set" button with 2 arrows either side.
Set some markers as you need them and map the set button and 2 arrow buttons to either pc keyboard or midi controller. The numpad buttons can be handy for mapping the actual markers. This because you can map Marker 1 to Numpad 1 and so on.
Hope this helps.
Re: How do i skip bars in the arrangement view
Posted: Fri Dec 04, 2009 4:39 am
by tlennon
You cannot traverse the cursor on a track without using the mouse like Pro Tools that allows for tabbing to transients and tabbing to beggining and end of regions. Sorry!
Re: How do i skip bars in the arrangement view
Posted: Fri Dec 04, 2009 3:20 pm
by emef
Star69 wrote:Hi guys
while cutting/splitting up an amen break in the arrangement view (using command e)
how do i skip to the next bar so i don't have to click the place on the break where i want to split it ?
i'm on pc, but for me it just a case of ctrl e to split then hit the right arrow key to move the split cursor to the next bit
maybe its not the same on a mac
Re: How do i skip bars in the arrangement view
Posted: Sat Dec 05, 2009 4:43 pm
by siliconarc
yup, arrow keys