Why does automation turn gray when I change a parameter?
Posted: Wed Apr 27, 2011 1:04 am
Hi!
Why does the automation (lines and points) turn gray when I change a parameter manually?
I open up a default set, drag a audio effect (utility for instance), go to arrangement view, draw some automation for the gain parameter. Then I manually change the gain value directly on the utility device. Instantly the automation curve turns gray; it's no longer possible to make any edits in that automation lane. Is this intentional?
One cannot undo the manual change either, which I find a bit strange.
Live 8.2.2
OSX 10.6.7
Why does the automation (lines and points) turn gray when I change a parameter manually?
I open up a default set, drag a audio effect (utility for instance), go to arrangement view, draw some automation for the gain parameter. Then I manually change the gain value directly on the utility device. Instantly the automation curve turns gray; it's no longer possible to make any edits in that automation lane. Is this intentional?
One cannot undo the manual change either, which I find a bit strange.
Live 8.2.2
OSX 10.6.7