mark egloff apc step seq

von haugwitz · Post by **von haugwitz** » Thu Jul 28, 2011 10:45 pm

Hi!
there is a problem with the apc step sequencer.
It only shows and update steps/notes only on the 4/4 in 1 bar.
It is possible to bring them in but after on cycle they are quantized agin to the 1;5;9;13 Step of 1 Bar.
First Time i load this patch everything works fine , after a unknown amount of time it starts to behave in this way.
maybe there are some others with this problem or anybody who can Help!

Thats one of the best patches.

atb
vh

JuanSOLO · Post by **JuanSOLO** » Fri Jul 29, 2011 4:07 pm

I have not experienced this problem, and I am not quite sure what you mean. Are you saying that after a while, it shifts the quantinization of the sequence over 1 quarter note?

von haugwitz · Post by **von haugwitz** » Fri Jul 29, 2011 9:19 pm

Hi!

First thank you for reply.

Yes and no.
Its not possible to set steps between the 1,5,9,13 Step in one Bar it behaves like quantization .
These Steps are just showed for one cycle if lives Transport is on and are also shown in the midi clip just for one cycle.
I was thinking about these auto quantization during record option but tried to switch this on and off.
In other words there appear only 4 steps of 16 a one Bar loop on the 1,5,9,13 Step
like a 1/4 quant (but with a step length of 1/16...thats clear i know).

mark egloff apc step seq

mark egloff apc step seq

Re: mark egloff apc step seq

Re: mark egloff apc step seq