Page 1 of 1
Push Touch Strip settings
Posted: Mon Apr 01, 2013 11:48 am
by oopfoo
Perhaps I'm overlooking the obvious, but I can find no reference to any settings for the Push Touch Strip control. In particular, I'd like to set the pitch bend range to be a bit wider. Is this possible, outside of some custom mappings?
Thanks,
Michael
Tallahassee, FL USA
Re: Push Touch Strip settings
Posted: Mon Apr 01, 2013 2:46 pm
by cyclicAMP
I believe the pitch bend range is set within the instrument/synth patch, not from the controller.
Re: Push Touch Strip settings
Posted: Mon Apr 01, 2013 4:21 pm
by anamexis
Right, in note mode it behaves like any other MIDI pitch bend. What it does is entirely up to whatever it is controlling
Re: Push Touch Strip settings
Posted: Mon Apr 01, 2013 11:07 pm
by rud
Same issue
+ LED discolorations
See my thread and suggestion for possible fix
Bump it if you think it's adequate.
viewtopic.php?f=55&t=191939
Re: Push Touch Strip settings
Posted: Tue Apr 02, 2013 3:26 am
by anamexis
That's not the same issue at all.
Re: Push Touch Strip settings
Posted: Wed Feb 19, 2014 5:44 am
by avastar
Hello,
Any answer to that thread? I really need my touch strip to bend wider than just the octave.
thanks
Re: Push Touch Strip settings
Posted: Wed Feb 19, 2014 2:19 pm
by yur2die4
cyclicAMP wrote:I believe the pitch bend range is set within the instrument/synth patch, not from the controller.
This is the answer. You can only change the pitchbend from the instrument plug in you are currently using by adjusting 'pitchbend range' in its settings. Different vsts etc might have different options for range settings.