Hey,
i am currently in a dead end and i might need some help or pin pointing to a solution. I will explain a little bit what i want try to achieve.i got a moog subharmonicon and want to change the pitch value of the OSCs to have the possibility to transpose the subharmonicon via live. There are Midi CC values for that. I was able to hook everything up and i am able to automate the pitch via cc knobs module i got online.
The problem now is i want to translate pianoroll data to change these knob pitch values. So i want to transpose not by knob (where you have no indication on note value) but by pianoroll. Currently the subharmonicon is tuned on C on all osc and sub osc. The knobs are centered on 64 to hold that C.
In the automation lane i only got the knob scheme but no pianoroll. The question is is it possible to enter piano note data translate them to feed the knob data? Or is there another solution i missing here? Otherwise need to have a take on Max.
Any suggestions?