Sustain pedal issue

Discuss music production with Ableton Live.
Post Reply
jazzersaxman
Posts: 2
Joined: Sat Jul 06, 2024 2:33 pm

Sustain pedal issue

Post by jazzersaxman » Sat Jul 06, 2024 3:29 pm

Hi,

I am not sure if I am doing something wrong or there's something I need to do.

I am using Ableton Live 12 and just upgraded my setup. I just purchased an Arturia Keylab 88 Mk3 controller with an M Gear sustain pedal.

When I try and record my midi tracks, the actual notes are recorded, but the sustain information doesn't show. Therefore every not is short. I can see the sustain pedal light up in the signal square in the top right corner of Ableton, but it's not recording the info.

The pedal polarity is correct. (I tried switching it and the notes would sustain until I clicked the note off, so I put it back)
I tried messing with the remote settings in the midi menu, and that didn't work.
Can anyone tell me what is wrong? It's 2024 why is this an issue!?
Thanks for any guidance.
Rich

royston
Posts: 38
Joined: Thu Dec 17, 2009 12:40 pm
Contact:

Re: Sustain pedal issue

Post by royston » Mon Jul 08, 2024 4:04 pm

I can assure you that it's not a Live issue.
So maybe it could be a problem with your M Gear pedal.
Have you already looked into the Midi Console of Arturia's Midi Control Center?
If your pedal works correct, you can see Midi messages when you're using the pedal.
Is this the case?

jazzersaxman
Posts: 2
Joined: Sat Jul 06, 2024 2:33 pm

Re: Sustain pedal issue

Post by jazzersaxman » Mon Jul 08, 2024 7:11 pm

In MIDI Control Center

This shows when I press the pedal
In:B0 40 7F Ch1 CC 64 Sustain

And this message when released
In:B0 40 00 Ch1 CC 64 Sustain

royston
Posts: 38
Joined: Thu Dec 17, 2009 12:40 pm
Contact:

Re: Sustain pedal issue

Post by royston » Mon Jul 08, 2024 8:57 pm

Good! Your pedal works fine.
Um..last question -
In Live settings, did you tick the Track box of your Midi controller?
(Input ports: your Midi controller / Track)
If yes, I'm clueless what's going wrong.

Rivanni
Posts: 820
Joined: Sat Nov 26, 2016 12:30 pm

Re: Sustain pedal issue

Post by Rivanni » Mon Jul 08, 2024 10:37 pm

jazzersaxman wrote:
Sat Jul 06, 2024 3:29 pm
When I try and record my midi tracks, the actual notes are recorded, but the sustain information doesn't show. Therefore every note is short.
Sustain information is not visible as note lengths. It's recorded as a MIDI ctrl message.
Go the the Envelope tab of the MIDI clip. At the bottom, select MIDI Ctrl in the first drop-down and 64: Sustain pedal in the second drop-down.
You should now see the sustain envelope.

lacruzmetal
Posts: 1
Joined: Sat Oct 12, 2024 10:12 am

Re: Sustain pedal issue

Post by lacruzmetal » Sat Oct 12, 2024 10:15 am

try this, it worked for me. open the midi options tab in preferences and uncheck the mpe box. step on the pedal and let me know

Post Reply