Wanting to use Push 3 Standalone to drive a portable eurorack system (not via the expression pedal outs, but via the ADAT outs). I have seen suggestions elsewhere that CV calibration of eurorack modules can be saved as a preset then ported into the Push. The one thread I've been able to find about it suggests this works, but I haven't been able to figure it out and the thread goes cold before anyone explained how to do it. Every time I try this, the only tones I can get in Standalone mode are several octaves higher than what they're supposed to be.
Works fine with a laptop connected, but trying to do it in standalone yielded failed results on each attempt. Is there a tutorial anywhere on doing this, or are those claiming it does work mistaken?