MELD Auto-Mapping

[Quiet Erp]

After a quick hunt online I drew a blank.
So.here is a list of Meld's auto mapped parameters. This is v. rough so please feel free to correct or link to an official version.

bank#1-8
Engine A
1-ON/OFF
2-KEY TRACKING ON/OFF
3-PITCH TRANSPOSE
4-TRANSPOSE SCALE DEGREES
5-OCTAVE
6-PITCH DETUNE
7-OSC TYPE
8-MACRO 1

1-MACRO2
2-OSC SCALE AWARENESS
3-OSC PHASE RESET
4-OSC PHASE SPREAD
5-FILTER ON/OFF
6-FLT TYPE
7-FLT FREQ
8-FLT MACRO 1

1-FLT MACRO 2
2-FLT SCALE AWARENESS
3-LFO1 TYPE
4-LFO SYNC
5-LFO RETRIG
6-LFO RATE HTZ
7-LFO RATE BEAT
8-LFO PHASE

1-LFO1 MACRO 1
2-LFO1 MACRO 2
3-LFO1 FX1 TYPE
4-FX1 MACRO 1
5-LFO1 FX2 TYPE
6-LFO1 FX2 MACRO 1
7-LFO2 WAVEFORM
8-LFO2 SYNC

1-LFO2 RATE HTZ
2-LFO2 RATE BEATS
3-LFO2 RETRIGGER
4-LFO2 PHASE
5-AMP ENV ATTACK
6-DECAY
7-RELEASE
8-SLOPE ATTACK

1-SLOPE DECAY
2-SLOPE RELEASE
3-SUSTAIN
4-ENV LOOP MODE
5-MODULATION ATTACK
6-DECAY
7-RELEASE
8-INITIAL LEVEL

1-PEAK LEVEL
2-SUSTAIN
3-FINAL
4-SLOPE ATTACK
5-SLOPE DECAY
6-SLOPE RELEASE
7-ENV LOOP MODE
8-MIX TONE

1-MIX PAN
2-MIX VOLUME
3-GLIDE MODE
4-GLIDE TIME

REPEAT FOR ENGINE B
banks8-15

bank#16
1-ENGINE B DELAY
2-DRIVE
3-LIMITER ON/OFF
4-LINK ENVELOPES
5-USE PROJECT SCALE
6-VOICE SPREAD
7-MASTER VOLUME

Hope this helps someone, coz it took ages.

[NIELS ON]

Here is a list by someone who decompiled the official scripts, the biggest challenge is to figure out the device names:
https://github.com/gluon/AbletonLive12_ ... Devices.py

It's a shame that Ableton forces us to learn programming just to be able to have a proper individualized control setup.
Even Apple is more supportive when it comes to control surfaces on their own DAW.