uc33-have to press buttons twice

alan* · Post by alan* » Fri Sep 23, 2005 12:28 am

anyone know why say if i assign the buttons on the uc33 to the cue buttons in live why you have to press them twice to make them go on or off, anyway of changing this so you only have to press them once ?

Emissary · Post by **Emissary** » Fri Sep 23, 2005 8:48 am

i think this is to do with the way your uc-33 buttons are setup. you should be able to change the way they trigger midi in a menu somewhere, so they are constant rather than like a switch. i am rubbish at explaining, have a read of the manual. hope i helped a little

telekom · Post by **telekom** » Sun Sep 25, 2005 12:32 am

Hi alan*,

Try the link below. I had the same problem but I was helped by another forum user. Also make sure you go to the evolution website and d/l the advanced manual (not included with the device for some wierd reason...)

http://www.ableton.com/forum/viewtopic. ... highlight=

HTH

sqook · Post by **sqook** » Sun Sep 25, 2005 8:17 am

The short answer to your question:

- Press the button you want to select it for programming
- Press the "DATA LSB" key twice
- Type in 127

After you've done this for all of the buttons, it's generally wise to store this information into a preset, as it will be lost the next time you power your uc-33 on.