Long Clip / Audible Click when Copying Bars in Arranger View

[tylast]

I'm using Live 2.3 & I've got a clip that is 1.5 min long & I've followed the long clip guide in order to get the warp markers just right. It's the only clip I have loaded. While in Arranger view, I've copied a few bars from the long clip (that is in Track 1) & copied them to Track 2. I've muted Track 1.

When any of the bars that I've copied to Track 2 transition from one copied loop to another....I get this audible click (varies in loudness depending on which loops connect). I've tried fading the volume at the transition point (even all the way down to zero) and I still hear the click (& the click volume doesn't change). Am I doing something wrong??? Is there an easier way of using multiple loops from this long clip (without having to use Wavelab to chop it up)? Any advice/help would be greatly appreadciated.

[harb]

tylast,

The sections that you are cuttting in the Arranger, do they loop properly in the session view?

In session view; If you set the loop points (in the clip view properties window) to the specific section that you are cutting in the arranger, does it still click and pop (when playing the clip in the session view instead of the arranger)?

If not, this may be a way to use multiple loops from your longer file...
Just set the loop points on multiple copies of your clip in the session view, hit record and jam with your loops....

Don't know if this is relevant...are you using any plugins on the audio?

What sort of audio material are you using? Does it contain a lot of low frequencies?


harb

[tylast]

DAMN! That totally works. Multiple thanks! Seems like that's a bug then. I should be able to loop either way without clicks. Oh well.