Page 1 of 1

how to save a device to clip???

Posted: Tue May 30, 2006 9:23 pm
by hibjr
for example. i created a beat. and i apply a pingpong delay to it. i want to have it set so the next time i drag this beat into a slot it will have the delay as i set it. i am aware that when i click on this beat in the broweser it plays with the delay. but when i drag it in it is gone. is there a solution?
thanks

Posted: Tue May 30, 2006 11:09 pm
by yogz
hi,
when you drag your live clip into an existing track w/effects on it, your clip appear without the effect.

yogi

Posted: Wed May 31, 2006 1:51 am
by j0shu@
so unless im missing something:

you put your beat in a clip
apply your effects
drag that clip to the browser
drag the clip from the browser to a slot without efx

it should have the effects and clip intact...

yes

Posted: Wed May 31, 2006 3:20 am
by chepnut
so unless im missing something:

you put your beat in a clip
apply your effects
drag that clip to the browser
drag the clip from the browser to a slot without efx

it should have the effects and clip intact...
Works 100%

Posted: Wed May 31, 2006 7:19 am
by EgAD
do you have to save your set as 'self contained' for this to work, what i want to do is this:

open a blank set, bring in alot of samples, mangle them with efx and drag the samples to organized folders in my browser, after this I want to delete the 'workshop' set that i created all of these device clips with.
if I delete this set, will I retain my new device samples that have been dragged into folders?

no good

Posted: Wed May 31, 2006 4:25 pm
by hibjr
thanks for the reply but still not working. when i click on the beat in just the browser it will play with the effects. however when it is dragged to a clip the effects are gone. this is fustrating, cause now i have to reapply the effects.

almost

Posted: Wed May 31, 2006 4:37 pm
by hibjr
ok when i double click on the beat in the browser, it opens up in a session slot with the effects. horray! however when i dragg it to a slot still no effects? boo!

Posted: Thu Jun 01, 2006 3:41 am
by EgAD
werd

Posted: Fri Jun 02, 2006 7:29 am
by djsynchro
If you drag it into an EXISTING slot, only the audio or Midi clip will appear.
This is so that you can drag just the audio or midi from an existing Live clip and use it in a channel you had already set up.

If you drag it over the returns and hold it, transparent clips will appear, let go of the mouse button and Live will create a new track, this will have the effects.

PS sometimes you have to hold the mouse and wait quite a bit for transparent clips to appear, when they do you can let go of the mouse button and the new track will be created. Live is a bit slow here and there this is one of those areas.

Also make sure to read the fine manual multiple times!