Ableton Forum

Hi,
Do any other Virus TI owners who generally have no problems, get this problem in Live 5.2

It happens when an 8 bar clip only has notes in bars 7 and 8.

This test is rock solid in SX 3.1.1
It maybe my settings in Live as I am fairly new to it, but I think I've tried everything.

Basically, create a midi clip to loop 8 bars but only have chords in the last two bars.

Results:
The TI does not play anything.
The TI plays sustained chords
The TI plays differently each time round the loop.
Setting the clip to loop just bars 7 and 8 causes TI to play correctly.


It may happen on any patch / arp pattern, but below is what I was using.

Exact method to recreate problem:
Load patch NuNRG into TI (Rom B No. 81)
Set Arp to chord
Set pattern to 50
Turn off delay (less confusing)
Create a loop 8 bars long
At bar 7 beat 1 - create 3 note chord half bar long
At bar 7 beat 3 - create 3 note chord half bar long
At bar 8 beat 1 - create 3 note chord half bar long
At bar 8 beat 3 - create 3 note chord half bar long


Rod

TI OS 1.1
Live 5.2
SX 3.1.1
XP SP2