How do YOU automate loop position

jaimelunn · Post by **jaimelunn** » Tue Jul 18, 2006 10:24 am

Sorry but I am struggling to assign a controller that can effectively move the position of the loop markers in a clip. I have a BCF2000 and I want to be able to move the position of the loop points within a clip with and without resizing. Right now all that happens when I make an assignment is that the loop opens and moves to the end of the clip.

Any ideas suggestions?? Really appreciated.

JAime

timothyallan · Post by **timothyallan** » Tue Jul 18, 2006 12:34 pm

adjust your global quantize, or the quantize of the clip. then you'll be able to create loops smaller than 1 bar...