Ableton Forum

i've read the evolver manual and tried plenty of trial and error, but i'm still not getting it.

how does one trigger the evolver's in-board sequencer from live? i'm assuming i set up a MIDI clip in live, route it to the evolver, and then set the evolver's "trigger select" function accordingly. but no matter what i try i can't seem to figure out how to simply start the evolver's internal sequencer FROM live when i hit start -- i can only actually trigger MIDI notes from live, or some weird combination of MIDI notes + then the evolver taking over. very frustrating. there must be something (probably quite obvious) i'm doing wrong.

thanks!

you have set up 2 things;

- Live to send sync..
- Evolver to receive sync..

Live;
go to preferences,
and set your midi out to send sync..

Evolver;
go to 'MIDI Clock' (main program, knob 8, upper right corner)
set clock to 'in'

you're done..

Pesky sync setting! Awesome, thanks so much. I knew it couldn't be too hard.

your welcome..

the original manual isn't that good..
more like technical papers..

this manual/guide is much better i.m.o.
http://www.carbon111.com/evolverguide.pdf

has loads of practical examples and really explains how things work..