Problems recording into Live 5 and 6

eighttwelve · Post by **eighttwelve** » Tue May 22, 2007 8:38 am

I'm new at this recording business so be easy on me.

I purchased the M-Audio FireWire 410 and MXL microphones to go along with Live 5 (which I have since upgraded to Live 6), using a Dell XPS M1710 laptop. Unfortunately, whenever I go to record, I am only able to get a few seconds of recording before the mic goes dead and I have to mess around with the input settings. This happens EVERY time. I have always had recording issues, but I simply let it slide at first, but I finally have had enough, so I came here for help. I've messed around with all kinds of settings, but nothing seems to work. I've looked through all the help and all the lessons found in the program, but nothing seems to help. If anybody has experienced something similar or can offer any help, I would greatly appreciate it.

Thanks.

eighttwelve · Post by **eighttwelve** » Wed May 23, 2007 4:53 am

Anybody?

P.S. I read somewhere that installing 6.0.5 would help, and I installed 6.0.7 because it was all i could find, but it didnt help at all.

cressy · Post by **cressy** » Wed May 23, 2007 1:31 pm

I've got exactly the same problem dude... I set audio-in to monitor, or record, or leave it armed, and after 5 seconds to 5 minutes all Live spits out of that track is a hummmmmmmmmmmmmmmmmmmmmmm...

It seems it's a rare problem that only effects people with Dell laptops and the M-Audio Firewire 410. I've tried EVERYTHING to fix it, trust me... (IRQ settings, SpeedStep in XP, Driver versions, Asio4all, Disabling everything that isn't being used in Device Manager, different versions of Abeleton, Removing all VSTs.....)

Though now I think of it, the only thing I've not tried is to use the onboard soundcard and see if it still happens...

Anyway, on Saturday I'm buying a new firewire interface... Good luck fella.

eighttwelve · Post by **eighttwelve** » Thu May 24, 2007 12:54 am

Shoot me an email ([email protected]) if you're able to fix it. I doubt I'll be able to return the device and it was quite pricey, so I don't know if i'll be able to purchase a new one.

Good luck to you too, man.

peak · Post by **peak** » Thu Jul 12, 2007 2:40 pm

the same problem...
only few seconds or minutes of recording and after no input signal into my ableton... i can continue to use normally the output, but no signal in my input
it seems a crash of ableton with my input M-Audio fw410
the output it'all right
I need to restart ableton so i can use the input but only for few seconds or minutes...

someone can help me!!!

Asus lap top - A6t
amd x 2

M-audio firewire 410
edirol pcr m30

ciao
paolo

leedsquietman · Post by **leedsquietman** » Thu Jul 12, 2007 5:36 pm

who makes your firewire chipset? Check in control panel.

Firewire can be flaky on all PCs not just Dell because of the massive variations of chipsets. Texas Instruments seem to work best, ricoh and ene not so well. My Dell laptop (a slightly older Inspiron 9100) uses Texas Instruments.

Also, microsoft broke firewire in the sp2 ugrade of XP, reducing throughput to one quarter of what it was. There is a patch available which fixed that problem.

http://support.microsoft.com/kb/885222/en-us

Problems recording into Live 5 and 6

Problems recording into Live 5 and 6

oh dear

input problem with Ableton/Maudio firewire 410