syncing trigger finger with ableton

thepowerofequality · Post by **thepowerofequality** » Sat Aug 25, 2007 11:27 pm

okay, sorry if this is something that should be obvious.

maybe it is in the manual, i dont know.

but i bought an m-audio trigger finger, and i cannot for the life of me figure out how to sync it up in ableton. i have my preferences set, and ableton is recognizing the trigger finger,

and i know you have to use midi mapping,

but i seriously have no clue where to start with midi mapping.

someone please help!

966sf · Post by **966sf** » Sat Aug 25, 2007 11:47 pm

What do you mean with where to start? which parameters to map to the trigger finger? Go to the M-Audio website. I think there is a video that shows an example of TF with Live. Presets 10 and 11 are made to be used with Live and Impulse. TF is good for Triggering samples and Loops. And experiment with pressure sensitivity on filter cutoffs etc. The trick, though is to integrate it within your setup. So post that to see if anyone has any tips.

4.33 · Post by **4.33** » Sun Aug 26, 2007 12:05 pm

you can do a lot with your tf, even control the whole set exclusively with it

midi mapping in live is dead simple. the next step is to understand what do you want your controller to do.

rtfm to fugure how to program the tf, make your own presets, organize, etc.

and here's an excellent trick on how to navigate in live using mackie control emulation: http://www.ableton.com/forum/viewtopic. ... ie+control