I have tried this both on the keyfax phatboy and the evolution XSession.
The problem is in both 7.02 and 7.03
With each I map the CC's to the track volume faders.
With pickup it appears to work once per session .The message at the bottom of the screen appears and the fader waits for the cc to hit the correct value. Once I change midi channel change the cc setting then return to the original channel. Pickup won't work until I restart Live.
I can't tell with scaling because I don't know what to look out for but it appears not to work at all.
midi takeover only works once per session
Same here.
as example
Mpd24
1st preset Fader: 1-7
2nd preset Fader: 8-12
if i start my project with 12 channels.
1st time if i pick up faders from 1-6 (preset 1) ,all is ok,screen shows ,waiting for correct value
to make a smooth pickup and no jump....if i move the preset to 7-12 faders(preset 2)
allthogh all is going well etc....
....but if iam going back to preset 1 (1-6 fader) i allways have drastic jumps,the screen dont shows,waiting for correct value it make a direct jump :-/
buggy!
Live 7.03 | MBP
as example
Mpd24
1st preset Fader: 1-7
2nd preset Fader: 8-12
if i start my project with 12 channels.
1st time if i pick up faders from 1-6 (preset 1) ,all is ok,screen shows ,waiting for correct value
to make a smooth pickup and no jump....if i move the preset to 7-12 faders(preset 2)
allthogh all is going well etc....
....but if iam going back to preset 1 (1-6 fader) i allways have drastic jumps,the screen dont shows,waiting for correct value it make a direct jump :-/
buggy!
Live 7.03 | MBP
There was another thread a few weeks ago with the takeover mode not working correctly when switching banks on the UC-33e controller.
No response from Ableton though
No response from Ableton though
Last edited by 8O on Tue Apr 15, 2008 9:35 pm, edited 1 time in total.
