Page 1 of 1
snap to grid with clip envelopes?
Posted: Fri Apr 11, 2008 5:07 pm
by Apocrypha
Hello. I am on version 6. I have used Live since version 3. In previous versions, I thought it was possible to snap breakpoints to the grid. For instance, when i try to make break points for the pan envelope on a clip, it doesn't snap to the nearest grid. It's moves like the grid is turned off.
I am not in draw mode, by the way. I am double clicking on the envolope and trying to make hard pans at every bar but I want it to snap to the grid.
But the grid is definitely on. Is there something I am missing or has it always been this way?
Posted: Sun Apr 13, 2008 6:32 am
by Apocrypha
Anyone?
Posted: Sun Apr 13, 2008 11:42 am
by heavensdaw
Hi, I think you should use 'draw mode' for this.
Hd
Posted: Sun Apr 13, 2008 1:17 pm
by Yhtomit
Isnt there some command to insert a breakpoint?
Posted: Sun Apr 13, 2008 1:22 pm
by Angstrom
if you press control it will be constrained to vertical only movement
Re: snap to grid with clip envelopes?
Posted: Sun Apr 13, 2008 9:57 pm
by andrewbrewer
Apocrypha wrote:Hello. I am on version 6. I have used Live since version 3. In previous versions, I thought it was possible to snap breakpoints to the grid. For instance, when i try to make break points for the pan envelope on a clip, it doesn't snap to the nearest grid. It's moves like the grid is turned off.
I am not in draw mode, by the way. I am double clicking on the envolope and trying to make hard pans at every bar but I want it to snap to the grid.
But the grid is definitely on. Is there something I am missing or has it always been this way?
always been this way
Re: snap to grid with clip envelopes?
Posted: Mon Apr 14, 2008 2:47 pm
by Apocrypha
andrewbrewer wrote:Apocrypha wrote:Hello. I am on version 6. I have used Live since version 3. In previous versions, I thought it was possible to snap breakpoints to the grid. For instance, when i try to make break points for the pan envelope on a clip, it doesn't snap to the nearest grid. It's moves like the grid is turned off.
I am not in draw mode, by the way. I am double clicking on the envolope and trying to make hard pans at every bar but I want it to snap to the grid.
But the grid is definitely on. Is there something I am missing or has it always been this way?
always been this way
Cool Thanks. I was hoping it would snap to the grid but if this is how it is, I'll just get used to it.