Ableton Forum

I've searched for "ages" and I got 937 hits...

Wow!

Thanks for the blinker...

Hi, to use BC EDIT your BCR needs to be connected via USB and should have the global settings to U-1 (usb mode 1) (you should see a green led (USB Mode)).

Make sure that you have updated your USB drivers and firmware from behringer's web seit.

Also BC Edit works only with java 1.4 and below.

It works! (two simple delay with 100% wet & 0 fb) Thanks Angstrom.

but it's kind of weird that you control the feedback with the send button on the return track.

Thanks for your response. Unfortunatley I don't think it works by adding two delay device, unless I'm doing it wrong. I've tried two different ways on a return channel: the first one is to have two simple delay device both at 175ms (350ms), the first device no feedback and wet the second one with 50 ...

Is there an option to configure Live's delay effect (ping pong, filter delay or simple delay) above 300 ms?

Fabfilters timeless VST goes to 5000ms. A nice delay on a snare drum that I've found is around 350-450ms of delay (with 87bpm). This is a typical dub effect.

Maybe any of you knows a way to ...

About your nasty whinning sound, it happens to me when I unplug the firewire cable when the sound card is being used. I have a 4pin to 6pin cable and the 4pin is not very solid, if I lift my laptop, it can go off... I don't know if it helps. I'm not experiencing any other problems with this ...

You will probably need to read the manual a few times to understand what you can do with your controlller and how to do it. That's the best advice I can give you. Use the software (enigma) or hit mem and progam change at the same time to edit the notes or CC number of each pad. You fist select the ...

thanks,

it worked, that's a good tip!

Hi,

Is anybody using more than two outputs in LIVE to a hardware mixer? I've tried the following set up at home using Echo Indigo DJ soundcard and a mixer:

three channel mixer - chan 1 - output 5/6 (mono)
- chan 2 output 3/4 (mono)
- chan 3 output 1/2 (stereo)

I have a Y splitter for the output ...

Hi everyone,

like the subject ask, is it possible. I think I read user in this forum do this, but I can't figure it out. Basically, I would like to not use the mouse and navigate up,down,left & right, just like with a regular mouse. Also, is it possible to assign the left and right click of the ...