Popping noise when using EQ Three with Crossfader

no_barcode · Post by **no_barcode** » Mon Apr 11, 2005 2:34 am

I get a "popping" noise when crossfading one audio track that has an EQ Three on it and an audio track that does not. It pops when I crossfade from 100% of the track that doesn't have the EQ Three to 99% or less. (Sort of sounds like I just turned on the EQ Three in the middle of playing the track.)

It tends to only happen once or twice during normal playing (like the first time I load the set and play it), then it'll operate normally (i.e. no popping from EQ Three.) However, it will **render to wave** with the popping noise everytime I render.

I can't seem to work around this... anyone else have this happen?

no_barcode · Post by **no_barcode** » Mon Apr 11, 2005 10:20 pm

I suppose I could just resample that entire track after playing it once (thus getting it to make the "pop", which only seems to happen once per session), mute the problem track - using the resampled track in its place, and then render to disk.

Damn, I'm good. That's why I make the big bucks.

no_barcode · Post by **no_barcode** » Tue Apr 12, 2005 10:50 pm

Okay, so I played around trying to figure out where some of these pops and clicks are coming from and it seems there is a short burst of crossfader B's signal sent to the the "Sends" channel when crossfading from 100% of A to any % of B.

I have a file! I can prove it!

Though that seems a little different from what I had experienced earlier... I think their if something wrong with the crossfader, or the returns/sends and/or the crossfader.