help with M-audio uc-33e

sluggo · Post by **sluggo** » Sun Jun 05, 2005 4:04 am

Hi,

I just got a UC-33. I plugged it in, and got the usual usb installation messages. It shows up in my device manager as USB audio devide. Properties on this say that it is the uc-33 and that the device is working properly. However, it doesn't show up as midi hardware in Live (or other programs).

I also have installed a uc-16 and a midiman 2x2. These work fine.

Any suggestions? Thanks,
s

glenclayton · Post by **glenclayton** » Sun Jun 05, 2005 12:25 pm

The problem coul be with having 2 M-Audio devices which both show up as 'Generic Midi' devices. Download the evoution drivers and install them following the instructions and then the UC33 will show up as a UC33 and the US17 as unsuprisingly a UC17.

Works for me with my UC33 and XSession. A further tip is to set one to send on channel 2 and the other on channel 3 and then you won't have any controller conflicts.

Good Luck

Machinate · Post by **Machinate** » Sun Jun 05, 2005 12:33 pm

yeah, i had that problem too. Download drivers, unplug, install, plug it in, should work.

sluggo · Post by **sluggo** » Sun Jun 05, 2005 2:52 pm

cool, thanks. I had been looking on the m-audio site for drivers and there weren't any. I have another question though, my controller is a UC-33e and the drivers are for a uc-33 (hardware/device manager lists it as a uc-33). Does this matter?

thanks

sluggo · Post by **sluggo** » Sun Jun 05, 2005 3:48 pm

Is the Uc-33e supposed to list two midi inputs? My computer is showing UC-33E midi In1 and uc-33e midi In2.

thanks

Machinate · Post by **Machinate** » Sun Jun 05, 2005 4:10 pm

yep. there's a midi input at the back, i think that's in2.