basic mono/stereo question

Duxx · Post by **Duxx** » Sun Jan 30, 2005 5:31 pm

when i put my bass guitar thru an audio track

how do i get it into stereo on ableton live 4?

it was easy to toggle on ableton 3

sweetjesus · Post by **sweetjesus** » Sun Jan 30, 2005 6:57 pm

add a "utility" plugin and then set width to the lowest value possible...

Duxx · Post by **Duxx** » Sun Jan 30, 2005 7:17 pm

cheers

and would i do the same when im micing up my saxaphone yea?

sweetjesus · Post by **sweetjesus** » Sun Jan 30, 2005 7:24 pm

yes you would

loren! · Post by **loren!** » Sun Jan 30, 2005 7:55 pm

I was just about to post a new topic... hmmm.

Anyway.......
Neat trick, may be handy.

But how do you take a stereo track and make two mono tracks? (Left/right)
This is after it has been recorded.

I'm useing a digidesign M box and want to record two vocal tracks at the same time (or just split L/R of my synth) I would rather not have to go through pro tools to do this.

any help.
Thanks.

mike holiday · Post by **mike holiday** » Sun Jan 30, 2005 8:04 pm

Duxx wrote:when i put my bass guitar thru an audio track

how do i get it into stereo on ableton live 4?

it was easy to toggle on ableton 3

set the input to only recieve one chanel

mike holiday · Post by **mike holiday** » Sun Jan 30, 2005 8:06 pm

loren! wrote:I was just about to post a new topic... hmmm.

Anyway.......
Neat trick, may be handy.

But how do you take a stereo track and make two mono tracks? (Left/right)
This is after it has been recorded.

I'm useing a digidesign M box and want to record two vocal tracks at the same time (or just split L/R of my synth) I would rather not have to go through pro tools to do this.

any help.
Thanks.

since you have a mbox i would use protools it will take you 5 seconds to split the sterio track into two mono tracks...

pepezabala · Post by **pepezabala** » Sun Jan 30, 2005 11:15 pm

copy the track, paste it into another. Put an utility effect on each, select mono with left channel on one, right channel on the other. ready. no protools needed.

mike holiday · Post by **mike holiday** » Mon Jan 31, 2005 7:38 pm

pepezabala wrote:copy the track, paste it into another. Put an utility effect on each, select mono with left channel on one, right channel on the other. ready. no protools needed.

yeah but you are wasteing resourses why not just split the track in 2?
then you only need 1 track in ableton

Robert Henke · Post by **Robert Henke** » Mon Jan 31, 2005 7:42 pm

if i understood correctly all you want to do is record a mono track, right?
Open the audio preferencies. Go to the Input Configuration menu and enable "mono" and "stereo" for your desired inputs. Afterwards you will get each channel as single mono channel and as stereo pair in the input chooser of the routing. Now you can easily decide if you want to record input 1 or 2 as mono input or 1 and 2 as a stereo input.

Robert

basic mono/stereo question

basic mono/stereo question

.

Re: basic mono/stereo question

in ableton three and a half seconds

Re: in ableton three and a half seconds