Ableton Forum

Thanks, good info, didn't know about all this.

Hi All.

Back on Live after many years away and just trying to get back up to speed but I've hit a block. I'm sure it's obvious to most of you but I can't seem to figure this out. I have an Electra One mk2 midi controller and I want to make a template on it, map it to Analog for example then save it ...

I've been away from Live for a LONG time so back to being a bit of a newbie. I'm dropping samples into clips and looping them up but often I have a sample that's say 5 bars long and I have a space of 4 bars, I want the sample to play once before moving on. Unless I've misunderstood, the clip stops ...

Hi.

Returning to Live after many years and I saw something in Live that I don't get. In the attached pic at bar 111 in the Arrange window it is a D note followed by an E, yet in the editor window below it is 2 E notes. What causes this? Being a recent returnee to Live I can't say what led up to ...

OIC! Is there a conversion mechanism without going through and re saving each one individually??

[jur] wrote: ↑

Tue Feb 18, 2020 2:38 am

stratblue wrote: ↑

Mon Feb 17, 2020 12:13 pm

It seems that it is sounds from the Live 8 Legacy pack that don't preview if that helps anyone...

Ok that make sense then. Thanks.

Why does that make sense?

It seems that it is sounds from the Live 8 Legacy pack that don't preview if that helps anyone...

Hi there.

I'm on 9.7.7 and I was previewing some pads just idly going down the list using the down arrow in the categories/sounds/pads section. They all worked fine until I got to pad-5th pad.adv which wouldn't preview. Neither would any others after that until I had scrolled a looooooooooong way ...

Hi there.

Please Ableton, please, why can't we name the inputs and outputs? You have had YEARS to do this. Due to some technical troubles I've just had to go through all my inputs and outputs testing each one to see where it goes, then writing it all on a sticky note. A sticky note! On my monitor ...

For anyone with the same problem, the plastic bits that the screws go into are totally shattered, it's not like it's had a hard life either, just in a drawer with a decksaver on for the last few years. Went in brand new and came out like this. Anyway, I've found that the decksaver just fits on the ...

Lost some of the screws from the base of my original Push, does anyone know how to get more?

TIA, Nick.

it's getting kinda annoying. I use Cubase mostly but I like the idea of Live and I want to use it more, I must have sunk at least a £1000 pounds into it with the different versions and the Push etc and every time I try to move over to it some snag crops up, I remember before it was clips not ...

Hi All

If I press the record button on the Push1 Live drops in and starts recording on the next 1st beat, as expected, then I hit the record button again and it drops out on the next beat 1, no problem, but if I enable 'fixed length', Live drops in and starts recording immediately at whatever beat ...

I had this problem but found it to be only with certain usb cables, try few others maybe?

You could use the spare encoder to make a model of Slash or Abe Lincoln in quicksand, it's pretty much done by the look of it.